CLASSIC® BOND DV PK AG-504 – SBR/LATEX 1 LTR BOTTLE | NASIR & SONS PAKISTAN

USES CLASSIC®BOND DV PK is used as bonding agent and site- mix mortar admixture for the following applications: ▪ Grouts and screeds ▪ Patch repair mortars ▪ Mansonry mortars ▪ Renders ▪ Tile adhesives   CHARACTERISTICS / ADVANTAGES The main advantages of CLASSIC®BOND DV PK are: ▪ Increased adhesion ▪ Reduced shrinkage and cracking ▪ Increased abrasion resistance ▪ Reduced permeability ▪ Improved workability ▪ User friendly ▪ Suitable on most common construction sub strates   BASIS OF PRODUCT DATA All technical data stated in this Product Data Sheet are based on laboratory tests. Actual measured data may vary due to circumstances beyond our control. LIMITATIONS Never use pure CLASSIC®BOND DV PK or CLASSIC®BOND DV PK-water mix directly onto the substrate as bonding bridge, always add cement and sand to the mix. ECOLOGY HEALTH AND SAFETY User must read the most recent corresponding Safety Data Sheets (SDS) before using any products. The SDS provides information and advice on the safe handling, storage and disposal of chemical products and contains physical, ecological, toxicological and other safety-related data. APPLICATION INSTRUCTIONS SUBSTRATE QUALITY / PRE-TREATMENT The substrate shall be thoroughly clean, free from dust, loose material, surface contamination and materials which reduce bond or prevent suction or wetting by cementitious materials. Delaminated, weak, damaged and deteriorated substrate shall be removed by suitable means before application. Rust, scale, dust and other loose and deleterious materials which reduces bond or con- tributes to corrosion shall be removed. MIXING Mix CLASSIC®BOND DV PK with the correct amount of water to produce a gauging solution. Pour part of the gauging solution into a suitable mixing container. While stirring slowly, add the cement sand mix to the gauging solution and mix thoroughly until a smooth, uniform and lumpfree mix is achieved. Within the mixing time add additional gauging solution to adjust to the desired consistency. APPLICATION METHOD / TOOLS Bonding Bridge Thoroughly pre-wet the prepared substrate a recommended 2 hours before application. Keep the surface wet and do not allow to dry. Before application remove excess water e.g. with a clean sponge. The surface shall appear a dark matt appearance without glistening and surface pores and pits shall not contain water. Using a stiff clean brush work the mix vigorously onto the substrate, forming a thin layer filling all unevenness, pits and pores. Always apply following layer of mortar “wet on wet” onto bonding bridge. Mortar Contact our company CLEANING OF TOOLS Clean all equipment and tools with water immediately after use. LOCAL RESTRICTIONS Please note that as a result of specific local regulations the performance of this product may vary from country to country. Please consult the local Product Data Sheet for the exact description of the application fields